The L-shaped squeeze tube holder comes with adhesive on the back, just peel and stick! The holder is available in black, white, red, gray, or clear (gray & clear not shown). The L-shaped holder is primarily intended to be used mounted on a vertical surface, as shown below in the first image. However, the L-shaped tube holder can also be used sideways, as shown in the image of an open drawer, or used on a horizontal surface as shown in the third image.

(For enlarged product views, click on each image.)

Mounting:

1. The adhesive used is intended to be a permanent adhesive. That means once mounted it should be difficult to remove, and once removed will most likely not remount without replacing the tape, or buying a new tube*eez^TM tube holder.
2. Mounting requires cleaning the intended mounting area adequately enough to free the area from dust, grease and oils.

1. Tubes vary a great deal in neck and cap dimensions. Some tubes will fit tighter than others. Some tubes may require a little twist. Please refer to the tube product list for squeeze tube products that have been tested in these holders (and please send us an e-mail if you have one to add to our list.)
2. Some tubes are provided with a "nozzle". It is intended that the cap be removed and replaced with the nozzle. The nozzle is trimmed to provide a controlled bead width. When using the tube-eez product to hold tubes with nozzles tightly screw on the nozzle and then back off one complete turn. This will allow the product to fit the tube-eez product while maintaining a good nozzle to tube seal.

1. Generally, the tube*eez^TM squeeze tube holders can be carefully pried off with a putty knife, but not cleanly. Once pried off, turpentine can be used to clean off the remaining tape and adhesive.